Main Menu

emblem placement on 2 scoop cuda hood

Started by 1970 cuda Joe, February 25, 2024, 11:00:37 AM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

1970 cuda Joe

The hood that on my car is an original Mopar 2 scoop hood but never had hood pins or engine emblems. I figured out the hood pins pretty easy but I need to know where the emblem holes go for the 'cuda 440-6. Everything was painted when I got it so I only have 1 chance to get it right. Any templates out there or some measurements? Thank you, Joe
1970 cuda 440-6, 4 speed, Moulin Rouge, re-creation

MoparCarGuy

RE: J54 - Sport Hood a.k.a. Cuda Performance Hood (two scoops).

I cannot guarantee this graphic is correct but somebody else can help confirm it.
Depends on if the emblem pin locations are the same for all different emblem versions. I would expect they are.

MoparCarGuy

I looked at the non-Shaker Cuda hood emblems and it appears the 2-pin (short pin) design is for the twin-scoop hood and the 3-pin (long pin) design is for the Shaker scoop.
Graphic below for Cuda 440-6 emblems but each of the Cuda 340, Cuda 383, and Cuda 440 emblems have the same spacing for the 2-pin emblems.


1970 cuda Joe

I had to wing it a little but I think I'm close...Joe
1970 cuda 440-6, 4 speed, Moulin Rouge, re-creation