Choke rod

madmax2b · December 08, 2017, 02:47:06 PM

I have a 1970 Challenger with a 383 4barrel with a 3/4" spacer under the Carb to make clearance for a modern AC compressor. The problem is the Choke isn't closing completely. Does anyone know of someone who makes custom linkages? The Carb is a Carter AVS.

Chryco Psycho · December 08, 2017, 03:34:59 PM

I have just made my own using similar gauge welding rod

headejm · December 08, 2017, 03:37:05 PM

Should be able to fab something up. Welding rod is a good idea.

RUNCHARGER · December 08, 2017, 05:18:32 PM

I think coat hangar is the right thickness, it's been about 30 years since I fabbed one up.

440 Six pak choke Started by Rosco234 on Engine, Transmission & Rear End	14 Replies 1564 Views	Last post: May 29, 2020, 10:25:26 PM by Chryco Psycho
TA / AAR Choke Assembly Started by VCODE on Cuda & Challenger General Discussion (ROSEVILLE MOPARTS)	5 Replies 927 Views	Last post: January 04, 2024, 04:49:54 AM by VCODE
Choke Assembly Started by VCODE on Parts Wanted	0 Replies 216 Views	Last post: January 03, 2024, 12:31:21 PM by VCODE
Choke thermostat Started by jlemler on Engine, Transmission & Rear End	8 Replies 1183 Views	Last post: June 15, 2017, 05:57:53 PM by 73440
correct electronic choke Started by Matt13 on Cuda & Challenger General Discussion (ROSEVILLE MOPARTS)	8 Replies 716 Views	Last post: October 05, 2023, 12:22:14 PM by Matt13