More fender turn signal questions

[1970 cuda Joe]

Happy Halloween everybody

I'm finally getting back to my fender mounted turn signal lights on the 1970 cuda.
There was a barrel clip that came with everything. I'm guessing that snaps into the fender & the light housing pushes through it...correct? Some of the drawings I've seen indicate that it goes below the fender. Thank you, Joe

[1970 cuda Joe]

Dennis from Kruzin Moons answered my question this morning. Thanks to the 78 people that looked at my concerns....Joe

[MoparLeo]

Tell everyone the answer in case someone else has the same question.

It really helps members to share information.
 It might help you someday.

[1970 cuda Joe]

I was correct on my thoughts of the barrel clip. It pushes into the hole in the fender & the pin on the t/s light housing pushes through it, kind of in the same manner as you might install emblems with pins instead of tape....Joe

[cuda hunter]

Thanks for the answer.  78 people didn't know the answer and now they do. Pics help also.
Glad you got the information!

[1970 cuda Joe]

Thanks for the answer.  78 people didn't know the answer and now they do. Pics help also.
Glad you got the information!

I didn't think it would be a hard question to answer. There was quite a few 70 cudas built with the A01 option....Yes? I'm just trying to put back some of the things that were gone. I had enough evidence to say that car had that option. I need to invest in another camera as mine died & I'm a flip phone type of guy.....Joe

[Jay Bee]

I added the A01 to may car and just used PAL nuts instead of the clip to secure those to the fenders. Picture is from another thread on here