What parts for your E-body would you like to see reproduced

[moparmadman69]

Just want to get some ideas on what isn't made currently for e-bodies (or A/B bodies) that is desperately needed. The hobby has come a long way as regards to parts availability but there are still some big holes out there.

[BIGSHCLUNK]

Seeing NIKKI is a 70 there's a bunch of 70 ONLY stuff and 'vert only stuff. Mostly small but...      Plastic trim under the radio comes to mind, I had a helluva time years ago looking for that. Took a chance on an ebay item listed as - hard to find wood grain package...     But got it cleaned it off and it turned out to be a nice piece. Hanger for the visors on a vert is another.... (in the middle that the nubs clip into).     
I'll wake up at 3 AM now thinking of 10 other things....     

[Rich G.]

Reproduction parts that actually fit! Although the few parts I got from OER were pretty good.

[autoxcuda]

71 wide hood molding center piece to go with the repro corner pieces that are available.

Dead nuts accurate 15x7 trim rings.

[7212Mopar]

1970 front bumperettes?

[1Burgfish]

  Roof support sheet metal that goes under the roof skin; from top of back window on Cudas to inner wheel well in trunk behind sail panels.

[cudamadd]

The clips that hold the wide Crome mouldings .On top of the doors for an SE challenger.

[Bpret]

I will 2nd the trim rings. Hard to believe nobody has made them. The current ones are awful.

[RUNCHARGER]

I'd like to see a convt. "kit". Decades ago they were available to turn a 65-66 Mustang coupe into a convt. I'd love see one for a Challenger at a reasonable cost. I realize it's a lot of stuff, however a lot of real convts. need those parts too.
I'd even think about building one if the top itself wasn't available but I'd like the proper A-pillar moldings etc.

[Topcat]

71' Cuda Hood release parts are way overdue.

The one that releases the hood.

[anlauto]

Rotors for the two-piece designed Kelsy-Hayes rotor/hub.