Changing the front turn signal light bulb on 70 Cuda

[jlemler]

Simple question here, I checked the service manual all I could find was an exploded view of the front turn signal housing.  What is the best way to replace/change the front turn signal bulb.  I see two black nuts on the top, I see two screws, and maybe I just pull the socket from the back, or turn the socket.  Simple question I know.  At this point better safe then sorry.
Jeff

[anlauto]

You'll have to remove the light as a complete unit, then dismantle by removing the two lenses, then you can get at the bulb.

[MoparLeo]

Very simple procedure. A good practice is to always replace both sides at the same time and clean those connections.
seal them with dielectric grease after reassembly to keep the water/corrosion out.