installed a new M & H repro wiring harness in my 74 Cuda. No signal lights?

[Penta Star]

went thru all the wiring ,column connector is in . power at fuse 8. hazard lights work. not sure where to start trouble shooting this. Everything else seems to work.

[Penta Star]

a new flasher fixed the signal lights, Map light grounds to dash frame thru the switch,(had refinished the dash frame so ground was compromised.) Now just dealing with the door switched dome light circuit. likely a ground problem, but I've checked every thing i can think of. Anybody got ideas? i have a couple of yellow/ yellow with black tracer connectors that are unplugged.one is male, one is female . they are not near each other , so they obviously don't connect to each other. i suspect that they ground this circuit out but when i run a jumper wire it doesn't seem to help.