340 Fan pulley height on a/c &P/s car

[BuzzBusby]

Hi. First post for me. Would anyone here know the dimensions of the fan pulley required for a 72 Cuda 340 with a/c & p/s ? I believe the 3 groove engine pulley I need is Part #3614377 but I'm not sure on the fan-w/p pulley. I figure around 2" in height but am not sure. Thanks!

[Chryco Psycho]

Welcome to the site 
Sorry I cannot help with the part # or dimention you need though 

[JS29]

    

[blown motor]

Welcome Buzz. I have a 74 Challenger with a 73 340. The car was originally an A/C car but it has been removed. I can't say for certain if the fan-w/p pulley is original or not but it measures 6 1/2" diameter and I would say 2 1/4" front to back (height?). Hope this helps.

[BuzzBusby]

Hi. Thanks for the replies. There's a few pulleys on eBay etc that vary between 2" & 2 1/8" or so. As best as I can measure just over 2" is what I need so I think I'm getting close. I see I'm not permitted to upload attachments so I'll type details here from the Broadcast sheet:
Its says "drive pulley"=77, "Fan Pulley"=27 . Drive Belts, P/Stg= 98, A/C=74. Hopefully someone here may be able to decode that to actual part numbers? Cheers.

[blown motor]

Can anyone help him out on the decode?

[6bblgt]

from the 1972 Parts Catalog (November '71 version):
some pulleys in '72 have the part number stamped on them

drive pulley (7-06-1) 77 = #3614377 - 318/340/360 with A/C 3-groove A, B, C, E-body
fan pulley (7-06-14) 27 = #3418227 - 318/340/360 with A/C 1-groove A, B, C, E-body

p/stg belt (7-03-1) engine to (fan to) power steering pump 98 = #2951898 - 318/340/360 with A/C 45.50" lg. A, B, C, E-body (non-Chrysler)
a/c belt dual (7-03-1) engine to alternator to compressor 74 = #3462974 - 318/340/360 with A/C 54.26" lg. A, B, C, E-body

[BuzzBusby]

Thanks so much. That data and the picture are very helpful. Cheers.