70 Challenger Heater Control Valve - 440 with A/C

[Michael_B767_ATP]

Hi,

I'm trying to figure out how the heater control valve bracket attaches to the fender on the passenger side of my car. The one on there is for a truck and it's on backwards, does anyone have any photos?. She is a 70 Challenger 440 with A/C.

Thanks
Mike

[71GranCoupe]

Not positive, but believe there are 3 dimples on the inner fender that matches the correct bracket you are talking about. I will see if I have any pictures 

[Topcat]

Here is what the  original looks like.
The bracket on the bottom.

http://www.originalair.com/images/parts/all/18-H30-111N%20with%20brackets.jpg

[Michael_B767_ATP]

Hi,

The one on the car now is free floating, held in place by the hoses.  Who would do such a thing... 

Thanks!

[Michael_B767_ATP]

Hi,

Yep, that's it!. I have everything except the clips, still trying to find those. Just need to see how it attaches to the fender.

Thank you!

[1 Wild R/T]

First photo, correct valve with correct bracket.... Hard to see everything  but in the next post maybe it'll get better...
Oh, BTW the bolt on the other side of the A/C hose is in the heater valve bracket...

[headejm]

This is what the bracket should look like.

[1 Wild R/T]

My car.. Correct bracket, I quit buying the correct valve when the fourth one failed...  One photo is the two bottom bolts which are below the valve, the other is the same as shown above..

[1 Wild R/T]

And a new inner fender with the two bottom holes clearly visible, on a non A/C car these are dimples....

[headejm]

One more shot of the bottom two bolts from a different perspective.

[71GranCoupe]

Here is the correct bracket for the 70/71 Ebody water valve as from the factory.  Another of the installed valve.

[Michael_B767_ATP]

Hi Everyone,

I cannot thank you enough, that is exactly what I needed.

Mike

[Michael_B767_ATP]

Hi,

Just one more quick question. Are the bolts 7/16 self taping?.

Thanks
Mike

[71GranCoupe]

 I am away from both cars that have factory air, but believe they are a tapered sheet metal bolt, not self tapping, may require a certain size hole to be drilled. Found the bracket and correct screws according to their ad. hope this helps. 

https://www.moparmall.com/E-Body-Heater-Valve-Bracket-3441883-barracuda-Chal-p/824-210.htm

[1 Wild R/T]

Those bolts look correct to mount the valve to the bracket but not the bracket to the fender....  The bolts to fender don't have a built in washer... I will try to get a picture tomorrow...