Adjusted Diaphragm clutch. Now pedal goes to floor ?

[Racer57]

Pedal had around 1"- 1 1/4" play. Thought I would tighten it up a bit. Adjusted linkage between throw out bearing arm and Z bar. Got back into car, pushed clutch pedal and now it goes 3/4 of the way to floor.  WTF did I do and please tell me its an easy fix. 

[Mr Cuda]

 Starting with the basics.  Has the over center  spring uder dash been removed yet?
It won't work with that installed.
Otherwise,  no clue.

[Racer57]

No spring. Now that I've calmed down, I suspect the throw out arm is no longer attached to the bearing. At least thats what I hope it is.  Too damn hot to mess with it now. Will check later.