Clutch pedal

[Trouble]

 My clutch pedal on my 70 barracuda seems to be low. The car is shifting fine. Also I am able  to take the clutch pedal and pull it up almost 4 inches though it's spring loaded and then push it back down again

[JS29]

@Trouble  to the forum! you should have about an inch of free play. I would adjust it tighter to an inch, and test drive.

[Chryco Psycho]

you need to lengthen the adjuster rod , with the pedal that low there is constant pressure on the release bearing & it will fail quickly

[Chryco Psycho]

Welcome tot he site from Panama as well 

[Trouble]

How far from the floor should my clutch pedal be  engaging?mine seems to be 2 inches from floor.

[Chryco Psycho]

you shoudl have 3/4 -1" of free travel at the top of the pedal travel , this way the over center spring will pull the pedal up all the way without lifting it with your toe under the pedal

[Trouble]

 I brought my 70 Cuda to a  transmission place to have him adjust my clutch because it was too low.
When I opened  the hood he told me  to step on the clutch. He said to me something must be broken because he doesn't see the linkage moving when I step on the clutch. I told him I don't have any problems putting the car in gear. This is a transmission place! Can anyone guide me along?

[RUNCHARGER]

Nope, just what Chryco Psycho told you.

[Chryco Psycho]

New generation of "mechanics" or technicians as they prefer to be called ...
Only used to cable or hydraulic clutches when you can find a car with a manual trans .
Need be to drop by ??

[Trouble]

 I wish you could! I live in Paramus New Jersey

[anlauto]

Pretty common actually

[RUNCHARGER]

You have to access the clutch rod from underneath the car. It runs from the clutch fork to the clutch crossshaft (or Z-bar). It is very easy to adjust.

[Chryco Psycho]

I have no plans to be in Jersey but I won't be far away !