Text only | Text with Images

E-Bodies.org Cuda Challenger Forum

Technical Shop => Body Shop => Topic started by: Swamp Donkey on April 15, 2021, 04:24:27 PM

Title: What all can I weld up?
Post by: Swamp Donkey on April 15, 2021, 04:24:27 PM
Hey @anlauto (https://forum.e-bodies.org/mlist/anlauto_19) I was wondering if I can weld up the last 6 holes I have circled.  And also curious what the 1..250 inch hole in the far right is for.  I'm copying you in your 3rd Gen Hemi build.   Thanks!
Title: Re: What all can I weld up?
Post by: anlauto on April 15, 2021, 04:38:36 PM
So if you are copying the car I'm doing with a manual transmission and a Dakota Digital Dash, then you can weld up the following holes:

Throttle cable hole
Speedo Cable hole
Clutch Switch Safety Switch Wire Hole

You will still need the two holes for the clutch pedal reinforcement bracket, the one hole for the dash reverse light wire.
Title: Re: What all can I weld up?
Post by: anlauto on April 15, 2021, 04:41:09 PM
Keep in mind it's easier to weld up a hole now and re-drill it if you have to, rather then have the car in final paint and realized you have a bunch of holes you don't need  :alan2cents:
Title: Re: What all can I weld up?
Post by: Swamp Donkey on April 15, 2021, 06:13:38 PM
The Clutch Switch Safety Switch Wire Hole, I'm guessing can be run in somehow with all the other wires that would go into the cab from the engine compartment.  My weakest part of anything automotive is wiring.   :haha:
Title: Re: What all can I weld up?
Post by: Swamp Donkey on April 15, 2021, 06:16:58 PM
I messed up.  I was thinking for the dash reverse light wire hole.  Thanks!!
Title: Re: What all can I weld up?
Post by: wes473 on June 09, 2021, 04:49:38 AM
One of those small holes on the right is for road lamps I believe.
Text only | Text with Images