Does anyone know if there is a reproduction wiring harness made for the safety switch on the side of the transmission? I pulled it out of my car and noticed the inside of the plug at one of the spade terminals looked melted away? I suppose I could cut the plug off and solder on new aftermarket terminals but I was hoping to use the correct plug.
Any idea what would cause that? Don't want it to happen again of course.
I believe you can buy the whole original style plug and splice it in a few inches away from the tranny
IT is the 2 prong plug for the reverse lights I believe not the safety switch wich is on the clutch pedal
I used to buy them about 5 at a a time from Evans wiring
http://www.evanswiring.com/
https://www.yearone.com/Product/challenger-cuda/hu260n
Quote from: Chryco Psycho on December 25, 2018, 01:19:29 PM
IT is the 2 prong plug for the reverse lights I believe not the safety switch wich is on the clutch pedal
I used to buy them about 5 at a a time from Evans wiring
Yes you are right. It's for the reverse lights.
Thanks guys...I think my problem in searching was I kept thinking safety switch rather than back up lights
glad to help :twothumbsup: