I suspect due to appearance that my switch is the original. I would like to buy a spare, but the sites I've found them on demand a core. Is there a place to buy them without a core ? Also, if it should fail, can it be bypassed ?
There must be someone just selling the part I'm thinking.
Yes they can be bypassed. Mine has been like that for 30 years.
Why do you need a spare ? if you have a problem JS Restorations can rebuild it .
With all the 4 spd conversions the demand for these switches exceeds supply & no one is reproducing them .
typical pricing If you can find one is $250 or more .
Yes, the switch can be bypassed. The green wire on the starter relay provide the ground signal from the clutch pedal switch (sometimes called the neutral safety switch or NSS). If you run a ground wire directly to the spade terminal on the relay where the green wire normally goes, you will have bypassed the NSS. Just make sure you have good connections on both ends of the bypass wire or you'll be opening your hood a lot. A 16 gauge wire will work fine. When I bypassed mine, I ran the wire to a grounding location on the radiator (maybe on the core support? I don't remember at the moment) on the upper portion of the driver side facing the engine using a ring terminal.
At the risk of stating the obvious, with the switch bypassed, you or anyone else starting the car have to make sure the car is in neutral and/or the clutch pedal is depressed or you risk the car moving unexpectedly.
Quote from: Chryco Psycho on March 26, 2021, 03:07:11 AM
Why do you need a spare ? if you have a problem JS Restorations can rebuild it .
With all the 4 spd conversions the demand for these switches exceeds supply & no one is reproducing them .
typical pricing If you can find one is $250 or more .
I want a spare so I can drive my car instead of waiting. :stayinlane:
Bypassing it is a very simple process, you could do that and still drive the car while your switch is of for restoration. I recommend SF-Resto of course :twothumbsup:
Check O'reillys they do sell an aftermarket switch Part #: 8486-05 for $18.99
Quote from: chargerdon on April 04, 2021, 07:28:12 AM
Check O'reillys they do sell an aftermarket switch Part #: 8486-05 for $18.99
Thanks Don, I'm gonna buy one of those :bigthumb:
There was no way I was going to pay the $250=$350 plus for original so I've had mine bypassed for years.
Quote from: chargerdon on April 04, 2021, 07:28:12 AM
Check O'reillys they do sell an aftermarket switch Part #: 8486-05 for $18.99
Have you used one ? How did you mount it ?
https://www.oreillyauto.com/detail/c/cole-hersee/cole-hersee-neutral-safety-switch/ch00/848605?q=8486-05&pos=0
Fellow member Dmod1974 modified a cheap $20.00 one from Amazon.
https://forum.e-bodies.org/electrical-and-audio/11/affordable-and-readily-available-clutch-safety-switch-alternative/20617/msg256088#msg256088
Quote from: dodj on April 04, 2021, 04:58:33 PM
Quote from: chargerdon on April 04, 2021, 07:28:12 AM
Check O'reillys they do sell an aftermarket switch Part #: 8486-05 for $18.99
Thanks Don, I'm gonna buy one of those :bigthumb:
There was no way I was going to pay the $250=$350 plus for original so I've had mine bypassed for years.
Exactly. A length of green wire, grounded inside the car (so everything appears to be correct under the hood) is inexpensive and effective.
Plus you have the advantage of being able to clear your car from an intersection by cranking the starter with the car in gear.
And you also don't have to preload the unlubricated crank thrust bearing by holding down the clutch and cranking the engine before there is oil pressure.