I've finally purchased new seat belts for the 70 Challenger and want to make sure I'm installing them correctly. I found an old post from 2018 showing a yellow Challenger (Cuda Cody's I thnk) and what I've done so far looks correct but want to make sure before I cut the carpet. Any tips to making the plastic fit better?
They never fit that great, but your car is missing the wire shields, which makes it fit worse....no worries, once everything is screwed in place, they won't move around :alan2cents:
Where did you buy the seatbelts? I am in need of some correct seat belts for my car...
Purchased them from Dave at Roseville. :)
thanks Alan. Don't recall there being any wire shields in it, the interior was pretty gutted when I got it and this is my first project.
They always break off :tired:
Hmm. When I put mine in, I had them positioned a little differently. On your second pic, i would turn it counter clockwise so that the part thats pointing up in the air is laying more flat. In other words, the face that has the hole in it for the seatbelt to go through, should be more horizontal. I dont know if this is "correct " but thats the way mine seemed to fit better.
Sent from my iPhone using Tapatalk
Do these things live under the carpet?
Quote from: dylo on April 12, 2021, 10:33:37 PM
Do these things live under the carpet?
1970 only YES
Ok dammit I just put my carpet in! I better address that before i put my seats back in.
Previously mine were on top of the carpet with offcuts glued to them. Now I know why my carpet is sitting strangely in that seat belt bolt corner.