Can some share a pic of the nuts for the rear finish panel for a 70 Challenger?
Thanks
Tom
The rear finish panel for a 1970 SE is held on by 2 different clip/nut combinations. The attached photos show the two clips on the left side. The right side is two of the three clips that hold the drip rail moldings on. I hope these help. :cheers:
Since the photos are flipped, the clip/nut combos you are looking for are at the bottom of the photos. :drunk:
Check this thread out. Might be helpful. :cheers:
https://forum.e-bodies.org/parts-wanted/25/70-challenger-se-finish-panel-clips/7798/