Print Page - Pre-bent SS brake lines.

Title: Pre-bent SS brake lines.
Post by: Rdchallenger on October 18, 2019, 03:10:29 PM

Does anyone make them for E-bodies?

Title: Re: Pre-bent SS brake lines.
Post by: Floyd on October 18, 2019, 03:12:56 PM

I got mine from Fine Lines:

https://www.sstubes.com/

Title: Re: Pre-bent SS brake lines.
Post by: MoparLeo on October 18, 2019, 03:21:49 PM

Just an FYI. S/S brake lines are difficult to seal at the fittings. Must be very tight...

Title: Re: Pre-bent SS brake lines.
Post by: anlauto on October 18, 2019, 05:38:24 PM

:iagree:

Title: Re: Pre-bent SS brake lines.
Post by: Brads70 on October 18, 2019, 05:52:30 PM

:iagree: x 2 I found I had to tighten them , loosen, then tighten again a few times to stop it from leaking.

Title: Re: Pre-bent SS brake lines.
Post by: JS29 on October 19, 2019, 05:30:56 AM

:iagree: Almost to the point of striping! :alan2cents:

Title: Re: Pre-bent SS brake lines.
Post by: RUNCHARGER on October 19, 2019, 07:51:35 AM

Hmm: I back them off and give them another shot but they always seem to seal without crazy force.

Title: Re: Pre-bent SS brake lines.
Post by: jimynick on October 20, 2019, 06:52:25 PM

Put a dab of never-seize between the flare nut and flare edge to allow the nut to tighten better due to lessened friction between them and use a good flare wrench, too. Mind your knuckles! :cheers:

E-Bodies.org Cuda Challenger Forum

Technical Shop => Wheels, Tires, Brakes, Suspension & Steering => Topic started by: Rdchallenger on October 18, 2019, 03:10:29 PM