E-Bodies.org Cuda Challenger Forum

E-Bodies Cuda & Challenger (sponsor: ROSEVILLE MOPARTS) => Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) => Topic started by: js27 on December 18, 2018, 09:19:07 AM

Title: Exhaust sound.
Post by: js27 on December 18, 2018, 09:19:07 AM
Anybody here ever just run straight mufflers without the resonators on a 70 Challenger and then add them on?
I was just wondering how the resonators would change the sound. I ran straight pipe off the headers and just the factory mufflers since I restored the car and was just wondering if there is a different in sound and or performance.
JS27
Title: Re: Exhaust sound.
Post by: RUNCHARGER on December 18, 2018, 05:53:17 PM
IMO; That will sound fine. It seems every E-body in the 70's and 80's had that setup. When I heard one drive by I could tell whether the resonators were in place or not.
Title: Re: Exhaust sound.
Post by: 70 Challenger Lover on December 18, 2018, 06:07:57 PM
I'm curious of the difference myself. Do they make resonators in 2 1/2"?
Title: Re: Exhaust sound.
Post by: Chryco Psycho on December 18, 2018, 08:20:19 PM
MIne was done that way also , sometimes you will get a drone depending on the mufflers used , exhaust can have a big effect on power
Title: Re: Exhaust sound.
Post by: roguedc72 on December 19, 2018, 12:52:57 PM
just wondered are those reproduction pipes or were they bent by an exhaust shop? exhaust is the next step for my 72 340.
Title: Re: Exhaust sound.
Post by: Burdar on December 19, 2018, 01:59:20 PM
With the mufflers being at the back of the car, they are going to take awhile to warm up and burn off the water that collects in them from combustion.  If you don't have them already, I'd add some weep holes down low at the back.  You can punch a hole in the back case down by the seam with an awl.  An 1/8" hole is more than big enough.  It will let the water escape and your mufflers will last longer.
Title: Re: Exhaust sound.
Post by: js27 on December 20, 2018, 06:09:28 AM
Quote from: roguedc72 on December 19, 2018, 12:52:57 PM
just wondered are those reproduction pipes or were they bent by an exhaust shop? exhaust is the next step for my 72 340.
The tail pipes are stock original the pipe from the headers to the tailpipes were bent at a local muffler shop. I bought a set of cheap Cherry Bomb glass packs that bolted to the headers and drove it to the muffler shop.
JS27