E-Bodies.org Cuda Challenger Forum

Can someone tell me where this stabilizer goes for the door glass?

 :bigthumb:

Thanks Cody, I am missing one, do you know if they make them, or does anyone have one they would sell?

You might check with Dave.  I know they make the other stabilizer, but not sure if anyone is making that one yet.  I normally have to find them on ebay or at swap meets.

http://www.rosevillemoparts.com/product_info.php/p/window-stabilizer-bracket-1970-71-e-body/products_id/9435

Thanks Cody!

Hazaah! I found the other one!

...crap, I never knew I was missing thouse.   :Thud:

Ok, new problem, the fuzzy is wore out, does anyone know of replacements for the fuzzy part?

Quote from: GoodysGotaCuda on September 09, 2017, 02:23:17 PM
...crap, I never knew I was missing thouse.   :Thud:

70 only thing @GoodysGotaCuda (https://forum.e-bodies.org/mlist/goodysgotacuda_66)

Quote from: ksierens on September 10, 2017, 04:49:55 PM
Ok, new problem, the fuzzy is wore out, does anyone know of replacements for the fuzzy part?

Use the fuzzy half of a strip of Velcro.  :cheers:

Thanks guys! :bigthumb:

I know this is from a little ways back . Alan you mention this is a 70 only item? I have seen theses in two sizes. This one looks short and I have seen them a little longer too! I guess 71-74 used the stabilizer brackets that Dave and others are selling with the one 1/4 bolt going through them and that's all I should have on my 71?
I have the screw holes in my doors where this one in the picture would go , but I don't have this type stabilizer brackets!