Print Page - 340 Heat Riser Part Needed

Title: 340 Heat Riser Part Needed
Post by: Floyd on December 02, 2021, 05:55:14 AM

Long shot, but I'll give it a try. I have an NOS heat riser kit that I'm using to rebuild my 70 340 exhaust manifold heat riser. The kit I have did not include the dowel pin (circled in the attached pic). Wondering if anyone used the repro kit and didn't replace the dowel/has a leftover I can buy? Does anyone know who manufactures these kits? I'll have to make one otherwise. Many thanks

Title: Re: 340 Heat Riser Part Needed
Post by: 69BFan on December 02, 2021, 06:18:43 AM

@Floyd (https://forum.e-bodies.org/mlist/floyd_415), contact Neil Jenkins at Dynamic Renovations as he manufactures these kits. Hopefully he would sell you one of the dowels.
http://www.dynamicrenovation.net/index.php

Title: Re: 340 Heat Riser Part Needed
Post by: Floyd on December 02, 2021, 09:21:55 AM

Fantastic. Thanks!

Title: Re: 340 Heat Riser Part Needed
Post by: CudaJim on December 09, 2021, 05:47:48 AM

@Floyd (https://forum.e-bodies.org/mlist/floyd_415)

Longshot back at you - If the repro shaft doesn't work out, I think I have an incomplete NOS heat riser kit for a 318, but that I believe has the shaft, if there's a chance the 318 and 340 shafts would be the same. Jim

Title: Re: 340 Heat Riser Part Needed
Post by: Floyd on December 09, 2021, 05:57:57 AM

@CudaJim (https://forum.e-bodies.org/mlist/cudajim_13646)

Dynamic Renovations hooked me up, but thanks for the offer. I don't know if 318s use the same dowel though.

Title: Re: 340 Heat Riser Part Needed
Post by: CudaJim on December 09, 2021, 06:01:00 AM

@Floyd (https://forum.e-bodies.org/mlist/floyd_415)

:twothumbsup:

Glad you're covered. I should have looked at your pic more closely, I thought you meant the main shaft. My incomplete kit is also missing the smaller dowel. Jim

E-Bodies.org Cuda Challenger Forum

Technical Shop => Exhaust => Topic started by: Floyd on December 02, 2021, 05:55:14 AM