Recent posts

#1

Parts / Misc For Sale / Re: for sale driver side mirro...

Last post by Skdmark - Today at 08:22:56 PM

What's the date code on the glass?

#2

B

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: 1970 'cuda brake issues al...

Last post by B5fourspeed - Today at 08:00:18 PM

When I measured mine the pushrod was about 3/16 to long.The thread lock they used at the factory is strong.I have been spraying carb cleaner to loosen it up.Probably will use heat if spraying it does not work.My brakes where not dragging.My last Cuda when I installed the brake booster I stepped on the pedal and the pushrod shot right out.I had the same 70 booster on my last car but this pushrod does not pull out.I have no clue how 1 came out and another one you have to take the booster apart.Are the pushrods different lengths for power disc and power drum.

#3

1

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: 1970 'cuda brake issues al...

Last post by 1970 cuda Joe - Today at 07:26:02 PM

Thanks for the link. I wish his pictures were better....Joe

#4

General Topics / Re: Funny pictures, memes, vid...

Last post by Brads70 - Today at 06:34:06 PM

#5

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: What did you do with your ...

Last post by blown motor - Today at 03:49:22 PM

Well at least they are concerned about their quality of work.

#6

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: 1970 'cuda brake issues al...

Last post by Bullitt- - Today at 03:24:58 PM

  Check against these pictures
http://www.brewersperformance.com/products.php?cat=279

#7

1

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: 1970 'cuda brake issues al...

Last post by 1970 cuda Joe - Today at 02:03:46 PM

As I'm putting things back together, I thought I ould ask about the cast connection piece of this assm. It has a hole on where it attaches to the pedal. Are these castings only used on "E" body cars with disc brakes? If it's used on other cars, how would I know if I have the correct one? It looks like it's stamped "BE" on the side. I had to borrow the picture...Thank you, Joe

#8

Parts / Misc For Sale / Re: 383 shaker base plate

Last post by mopar jack - Today at 12:58:21 PM

hope you get to sell this part, just wondering if you have the adapter ring available

Sorry no ring. When I pulled this base plate I upgraded to a six pack and reused everything.

#9

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: What did you do with your ...

Last post by Brads70 - Today at 12:53:15 PM

Stopped by the bodyshop today. They are painting it again as they were not happy with the results. Tough colour to paint they said? Maybe get it back atvthe end of next week.

#10

Wheels, Tires, Brakes, Suspension & Steering / Re: Power Steering Issue

Last post by 7212Mopar - Today at 12:46:55 PM

Overheating issue. The pump is constantly spinning turning the fluid over when driving but you are not turning much. Energy put in that is not used turns into heat. Try new power steering fluid with higher temp rating might help or install a PS cooler.