Text only | Text with Images

E-Bodies.org Cuda Challenger Forum

Technical Shop => Reference Material => Topic started by: Cuda Cody on January 09, 2017, 10:40:56 AM

Title: 7 Step Paint prep process for E-Bodies
Post by: Cuda Cody on January 09, 2017, 10:40:56 AM
You can usually see the dip line still inside cars.  Sometimes even several of them.
Title: Re: 7 Step Paint prep process for E-Bodies
Post by: Mopar5 on July 31, 2019, 03:57:20 PM
That is attention to detail. Most people never pay attention to that but when you  chemically strip an e body if you look closely you'll still be able to see that line . I believe it's an 18 inch dip line.
Title: Re: 7 Step Paint prep process for E-Bodies
Post by: Mopar5 on July 31, 2019, 04:00:46 PM
According to the sheet it's 22 inch . It's funny a lot of people don't know the reasons for the plastic pan plugs they where there to fill the drain holes from dipping.
Title: Re: 7 Step Paint prep process for E-Bodies
Post by: Rich G. on July 31, 2019, 06:25:25 PM
If they dipped the car why do they all rot out? They must have dipped them in water! LOL
Title: Re: 7 Step Paint prep process for E-Bodies
Post by: PLY474 on July 31, 2019, 08:54:16 PM
Rear quarter view from the trunk, shows the lift angle of the car coming out of the vat of gray primer. 
Title: Re: 7 Step Paint prep process for E-Bodies
Post by: tparker on July 31, 2019, 08:56:34 PM
Now you post this. I just finished painting my car. Now I have to start over. :rofl:
Text only | Text with Images