E-Bodies.org Cuda Challenger Forum

Technical Shop => Body Shop => Topic started by: BFM_Cuda on May 30, 2019, 08:06:07 AM

Title: Body alignment measurements question
Post by: BFM_Cuda on May 30, 2019, 08:06:07 AM
Am I reading this chart correctly?

From the "O" line, is it 2.75" to the bottom of the frame rail, and 8" to the center of the spring perch?


Looking at the chart and car, the difference between the two measurements is 5.25", but the perch isn't that high above the frame rail bottom. So, i'm a little confused..
1971 barracuda/challenger show the same numbers in the red circle.


(https://i953.photobucket.com/albums/ae14/Darins701/frame1_zpsqql7xwlp.png) (https://s953.photobucket.com/user/Darins701/media/frame1_zpsqql7xwlp.png.html)
Title: Re: Body alignment measurements question
Post by: Cuda Cody on May 30, 2019, 11:17:30 AM
I don't think the 8" is taken from the 2.75"?  See the 5"?  Where is it taken from?
Title: Re: Body alignment measurements question
Post by: RJChallenger on May 30, 2019, 12:40:45 PM
That's not an 8,  as in 8" The letter E and F as well as the #8 could be reference points. the drawing says from the center of the frame bushing hole to the body center line is 2.75". You need to see if there's a chart on one of the pages that tell you what the E&F as well as the #'s mean ,ie view from this angle or maybe an exploded view of that part.
Title: Re: Body alignment measurements question
Post by: BFM_Cuda on May 30, 2019, 12:40:47 PM
Quote from: Cuda Cody on May 30, 2019, 11:17:30 AM
I don't think the 8" is taken from the 2.75"?  See the 5"?  Where is it taken from?

I guess what I am asking is, "what are the two points being measured at 2.75"? From the "O" line to what? "

I believe the "O" line to the spring perch center is 8".
Title: Re: Body alignment measurements question
Post by: RJChallenger on May 30, 2019, 01:48:50 PM
All dimensions given are to decimal points ie .75 or three quarters of an inch , 56.88 or fifty-six and seven eights. That 8 is meaningless in the equation.