Print Page - 426 Hemi motor mount boss not drilled

Title: 426 Hemi motor mount boss not drilled
Post by: 484HemiCuda on December 09, 2019, 06:08:59 PM

I have a Gen 2 426 Hemi from Mopar Performance that has been built. However the Hemi motor mount bosses have not been drilled. I need a fixture to locate the holes. Any suggestions on where to get a fixture to locate the holes?

Title: Re: 426 Hemi motor mount boss not drilled
Post by: Chryco Psycho on December 09, 2019, 06:33:56 PM

Welcome to the site from Panama :wave:
Unfortunatly I don't have a template for those holes

Title: Re: 426 Hemi motor mount boss not drilled
Post by: Flatdad on December 17, 2019, 05:13:55 AM

I measured this from an old Keith Black water block. The lower three holes are the crossbolt holes.

E-Bodies.org Cuda Challenger Forum

Technical Shop => Engine, Transmission & Rear End => Topic started by: 484HemiCuda on December 09, 2019, 06:08:59 PM