E-Bodies.org Cuda Challenger Forum

Technical Shop => Engine, Transmission & Rear End => Topic started by: 73chalngr on April 22, 2020, 03:07:33 PM

Title: 727 transmission mount
Post by: 73chalngr on April 22, 2020, 03:07:33 PM
 I have a small block 727 transmission are there supposed to be shims between the trans mount and the transmission and if so what size and where could I get some?
Title: Re: 727 transmission mount
Post by: anlauto on April 22, 2020, 04:10:24 PM
None of the applications use shims "between" the mount and the transmission. they use a rectangle shaped washer between the bolt and the mount.
Title: Re: 727 transmission mount
Post by: 73chalngr on April 23, 2020, 01:28:11 PM
Do you know the dimensions of the washers so I can make some ?
Title: Re: 727 transmission mount
Post by: Chryco Psycho on April 23, 2020, 04:51:59 PM
They are about the same length & width as the ear on the mount & .125 thick
Title: Re: 727 transmission mount
Post by: 73chalngr on April 24, 2020, 03:53:32 AM
Thanks  .