I bought a complete tray kit. I cannot figure out the brace. It bolts to the inner fender but there is no place for it to bolt to the tray. There is a hole to the back but none for the brace.
Is this a senior moment? Maybe
Tray maybe improperly made missing the needed hole , the brace should be vertical bolted to the inner fender , you my have to drill a hole for it
Ya, post a photo of the tray if you can. I've seen lots of reproduction battery trays with the hole in the wrong spot. That's what my money would be on. :bigthumb:
Quote from: Cuda Cody on April 29, 2017, 07:58:44 PM
I've seen lots of reproduction battery trays with the hole in the wrong spot. That's what my money would be on. :bigthumb:
:iagree:
Hole's usually off by 2" or so.
Yup I agree, poor quality reproduction tray need a hole drilled in it. :alan2cents:
Must be a lower quality company
Sorry it's been so long to get back. The tray is AMG? Guess I'll be drilling.
Are you talking about the upper or lower brace? I found I needed to get as many bolts in it as I could, and then using a tapered bar, wrench it into position to get the last bolt in- and it worked. The bottom one goes into a moveable J-nut and should offer some adjustment. Just my :alan2cents:
I believe there is only one brace under the tray. Just need to drill a hole and put the bolt in.