The Phoenix Graphics web page is showing an option to get the Scat Pack Bees decals. Their page says that they were on all 1970 Dodge muscle cars. Is this right? Are these proper for our car, 1970 Challenger, 383 R/T? They are cool, but I don't want to put them on the car if it makes us look like idiots who don't know that they don't belong.
Yes, they would have been on your car.
All R/T's.
pretty sure the decals are right for your car. I have them on mine, a 383 R/T.
Yes, A66/ 340 performance package as well as R/T and TA. :alan2cents:
There is an engineering drawing in our Resources section showing proper placement. :ohyeah:
The good decals have the backing paper cut so it sits on the window correctly with the paper up against the weatherstrip so you cannot go wrong .
:iagree: yes I agree, but also installed by humans :dunno:
The decals I bought for my A66 70 Challenger had alignment guidance on the backing sheet.
I had some NOS ones, but they must have been for an A or B body as the shape wasn't the same as the corner of a Challenger window. But the backing papers from my originals turned up under my carpet when I disassembled the car! So I used those for a template to trim the backing paper on my NOS set. Getting the decals off the backing paper without tearing the ancient decal was a chore too, but with time and patience I got it done.
Were they on all A66 cars? Mine is a 340 convertible not an R/T . Where do they go and is that something that would be shown on the broadcast sheet?
The should go in roughly the same position using the measurements & yes yours should have them but they were not on the broadcast sheets