Anybody have suggestions for removing this trim? I tried a block of wood and hammer, maybe a bigger hammer?
Undo the stainless at the bottom and pry off from the bottom up....
I removed the 2 screws at the bottom, I will try prying it off tomorrow.
Thank you! :fingerscrossed:
I use lacquer thinner to soften up the tape and get a razor blade to dig out some of it too.
I removed this morning, super easy with a little help from a heat gun. Once heated it pulled off and no hammer or block needed. The lower section I pulled off without heat as it was a little loose.
Pretty sure I have to use a hammer and block of wood to install.
I ordered glass sealing tape to reinstall glass into the channels, not knowing how to install I searched and found some cool instructional videos, thought I would share:
:veryexcited: :woohoo:
removal of channel from glass:
https://youtu.be/puzmpQ3Go5Y (https://youtu.be/puzmpQ3Go5Y)
installing the channel / trim with sealing tape:
https://youtu.be/zUY1XXIBiiA (https://youtu.be/zUY1XXIBiiA)