Print Page - Gen III and aftermareket gauges

Title: Gen III and aftermareket gauges
Post by: kjwalters on July 04, 2017, 04:34:51 AM

Hello guys, I have a question I am hoping one of you can help me with. What is the best way to get signal to a set of new gauges on a Gen III hemi? Should I just tap into the wiring harness for each gauge or?

Thank you
Jamie

Title: Re: Gen III and aftermareket gauges
Post by: GoodysGotaCuda on July 04, 2017, 06:33:42 AM

I assume you have a factory harness?

What gauges? Are the gauges calibrated to a factory Hemi sensor?

I have a custom harness and gauges for a gen3

(https://uploads.tapatalk-cdn.com/20170704/89ab94db394b22192bb1e491d44163b4.jpg)

Sent from my iPhone using Tapatalk

Title: Re: Gen III and aftermareket gauges
Post by: kjwalters on July 04, 2017, 03:02:46 PM

I have and aftermarket harness from autowire. I will be using Speedhut gauges. Most, if not all automotive sensors are 5v as far as I know. Nice setup by the way.

E-Bodies.org Cuda Challenger Forum

Technical Shop => Electrical & Audio => Topic started by: kjwalters on July 04, 2017, 04:34:51 AM