E-Bodies.org Cuda Challenger Forum

What's the going rate these days for a 489 case 3.23 SureGrip 8 3/4" center section?

Large yoke, gears etc appear to be decent.

TIA.

I just paid $900 for that exact config , but I needed to keep moving on my project and I wanted that finalized. Shipping was crazy

Where are you located?
What is the date on the ring gear?

I'm in Toronto, Canada.

Will check the date on the gear, but shipping may be very expensive from here

Most likely too cost prohibitive for me.

Plan a trip (or if you have a friend going) to Moparfest, New Hamburg, Ontario and pick it up. I'm sure YYZ will be there.

Quote from: Jay Bee on April 28, 2023, 01:55:32 PM
Plan a trip (or if you have a friend going) to Moparfest, New Hamburg, Ontario and pick it up. I'm sure YYZ will be there.

if not, I will pick it up and bring to the fest for you...if I don't buy it first.   :yes:

Is the WIW price for a cone or clutch setup?

@GrandpaKevin (https://forum.e-bodies.org/mlist/grandpakevin_594) brought up a very relevant question.  Some folks on the forum have commented they prefer to stay away from cone setups.

The casting date on the housing and the dates on the carrier, ring and pinion may be important to potential buyers.