I am mocking up my exhaust with a temp set of Headers I borrowed, either Hooker or Headman I forgot which. I got most of it laid out and it looks like the exhaust is pretty close to mating with headers which was a little bit of a suprise since TTI supplied my with 2 90 degree pipes that are used to connect the header to the exhaust. I'll get in there later today or tomorrow to see if I actually need it. But I am curious if others needed this piece or did it all just line up? It would be nice if My Dougs Headers lined up.
Tom
My Dougs headers for a B block did not line up w/ a set of 3" TTI exhaust. Had to use the two elbows to complete the connections.
It looks like the collectors on the Dougs go straight back, and the ones on TTI angle toward the center line of the car.
Ugh, I was hoping it would align. These temp heads "appear" to align but once I am out there again I'll probably find they are off a bit.
Thanks
Tom