E-Bodies.org Cuda Challenger Forum

Technical Shop => Reference Material => Topic started by: Roadman on October 13, 2017, 09:18:44 AM

Title: Bellhousing identification.
Post by: Roadman on October 13, 2017, 09:18:44 AM

While I've been looking around for a bellhousing for @torredcuda (https://forum.e-bodies.org/mlist/torredcuda_122) I tripped over this casting # chart From Roseville. Good info. http://www.rosevillemoparts.com/reference_castingnumbers5.php

Title: Re: Bellhousing identification.
Post by: Roadman on October 13, 2017, 09:23:26 AM

So according to the chart, for a 73 Bbody 400, 4 speed either a 2892511 or 2892513 would work. Am i correct in assuming the difference is the front bearing retainer diameter. ?

Title: Re: Bellhousing identification.
Post by: Cuda Cody on October 13, 2017, 09:31:36 AM

The 513 is a common big block bell. I've got a few around here that I can check if needed. Not sure on the 511 bearing diameter.

Title: Re: Bellhousing identification.
Post by: anlauto on October 13, 2017, 09:40:19 AM

Same bellhousing 511 is the part number 513 is the casting number :alan2cents:

Title: Re: Bellhousing identification.
Post by: torredcuda on October 14, 2017, 05:04:36 AM

Quote from: Roadman on October 13, 2017, 09:18:44 AM
While I've been looking around for a bellhousing for @torredcuda (https://forum.e-bodies.org/mlist/torredcuda_122) I tripped over this casting # chart From Roseville. Good info. http://www.rosevillemoparts.com/reference_castingnumbers5.php

Ya, saw that also and wasn`t sure if there was a difference or not.

Text only | Text with Images