Main Menu

Ignition switch wire removal for A01

Started by HUSTLESTUFF, May 17, 2017, 04:17:51 PM

Previous topic Next topic

0 Members and 2 Guests are viewing this topic.

HUSTLESTUFF

It's been a while since taking out the wires from the plug. Any help Cody

Cuda Cody

The A01 light does not go in that wire loom.  It's a separate wire that connects by itself.

If you need to get those wires out of that connector piece, you can use a wire terminal tool:

https://www.amazon.com/Lisle-57750-Wire-Terminal-Tool/dp/B007WQQHA2

Or use a small screw driver and press the tab down that hold them in.  Either way works pretty much the same.  If you need to re-install the wire all you have to do is lift the little metal tab up and it clips right back in.

Cuda Cody

You can see the little tabs in this photo:


1 Wild R/T

The round terminals are harder to remove from the connector without something like the proper tool... A screwdriver is bulky & you have two tabs to release...   Instead see if you have an old ball point pen, the with a brass ink cartridge.. The tube can be slide between the connector & terminal & that releases the lock tabs..

fc7cuda

Quote from: 1 Wild R/T on May 17, 2017, 06:46:32 PM
The round terminals are harder to remove from the connector without something like the proper tool... A screwdriver is bulky & you have two tabs to release...   Instead see if you have an old ball point pen, the with a brass ink cartridge.. The tube can be slide between the connector & terminal & that releases the lock tabs..

Good idea :bravo: