Rear speaker fader switch hole location

[Skdmark]

I need verification of the hole location for the rear speaker fader switch on an A/C Rallye dash bezel.
Below is what I have for a non-A/C bezel. I don't want to assume they are the same measurements.

Measuring from the top right corner of the bezel:
How far down from the top edge?
How far to the left from the right most vertical edge?

[6bblgt]

this is the best I can do - but it has to be in the same location, there is a cutout in the metal frame for it

[Skdmark]

@6bblgt  Thank you!

[cudamadd]

Welcome to the best mopar forum . Please tell us all about your car .Were you got it from and so on.cheers 

[Skdmark]

I came across some additional pictures and measurements regarding the rear fader switch location over on moparts.
In addition to the 1/2" hole there can be an 1/8" hole at 12 o'clock and 3 o'clock positions. Both are 13/32'-7/16" out from the center of the 1/2" hole.
One hole is for the pin on the back of the "speaker" bezel and the other is for the fader switch.

@cataclysm80
I think a couple of these images yours. If you want me to edit this post and remove them let me know.


1. Non-Rallye
2. Rallye with AC
3. Rallye without AC