E-body Parts

[Claudia]

Shoot me a message with an offer if you can use any of the parts listed below.
All parts are Mopar / E-body unless noted otherwise below. 
I can provide detailed pictures of each part as needed.

'72 - '74 Challenger Grill Emblem
'70 Cuda Front Turn Signal Housing Set
Summit One Way Fuel Check Valve
Holley Fuel Pressure Regulator
(2) Packs Hose Clamps
RB Distributor
6 Cylinder Thermostat Housing
Big Block Thermostat Housing
In-line Fuel Filter
Earl's (0 - 15 PSI) Fuel Pressure Gauge
Dust Cap Set
RB Real Main Seal
Clutch Fork Boot
904 TF Transmission Gasket
(3) Front Shoulder Belt Holder Covers
1 - RH A / B-body Interior Door Handle
1 - Interior Door Lock Lever
1 - Exterior Door Handle Gasket
1 - Exterior Door Handle
1 - Exterior Door Handle Lock
2 - Seat Belts
Coat Hook Set
1 - Rear Taillight Wiring Harness Bracket
1 - Rear Quarter Panel to Floor Bracket
1 - Rear Quarter Foot Well Body Plug
(2) Headliner / Sail Panel Retaining Tack Strips
New Reproduction Rear 6 x 9 Speaker Set
2 - Spare Tire Hold Down Brackets
1 - Wheel Cylinder
Cuda Rear License Plate Bracket w / Mount
Trunk Lock
'70 Cuda Chrome Tail Light Bezel Set

[71villianger]

you have pictures of the windshield lower molding?

[Cuda_mark]

@Claudia Could you send me closer up pictures of the lower windshield moldings front and back?

[Claudia]

@71villianger @Cuda_mark

Here are some better pictures . . .

[71villianger]

50$ on the corner pieces?

[Claudia]

PM sent.

[71villianger]

it wont let me reply yes since im new.  please email me at tsjag17@aol.com    it would be mailing to tampa fl 33610

[Claudia]

Updated list.

[Claudia]

Updated list.

[SFEBODY]

Looking for a restsored, NOSA or good operating condition passanger door latch with rods or without.   let me know what you may have?

[Claudia]

I only have the parts listed above currently available.

[SFEBODY]

'70 Cuda Front Turn Signal Housing Set, can you shoot me prices and photos

[Claudia]

@SFEBODY PM sent.