Main Menu

70 Cuda fog lights

Started by drew43a, December 16, 2020, 01:47:03 PM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

drew43a

Looking for a set of fog lights for my 70 cuda.

anlauto

I assume you mean "Road Lamps"...do you need just the bulbs or the whole set-up ?
PG Classic carries everything you need  :alan2cents:

https://pgclassic.com/cuda-road-lamp/
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

drew43a

yes road lamps.  i need everything but the dash switch.  but i don't want new.


anlauto

I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

Cuda_mark

Quote from: anlauto on December 16, 2020, 04:57:02 PM
OH...quite often you'll find used ones on eBay, but most times they're not worth the effort...  :alan2cents:

https://www.ebay.ca/itm/Mopar-1970-71-Plymouth-Cuda-Road-Lamp-Housings/223451957736?hash=item3406c649e8:g:W48AAOSwZ79cjuDX

The PG Classic ones are nearly identical to the originals too, if I recall correctly.

b5cuda

I got a set from BEA parts, they were excellent repro's.

anlauto

The ones sold by BE&A are manufactured by PG Classics :bigthumb: so one in the same :yes:

If you don't want to deal with cross border shopping, reach out to BE&A, they may still have some available. :dunno:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration


drew43a

well after a lot of searching i did find NOS original bulbs on the internet.  I think the $35.00 each was a good deal compared to the $169.00 for 2  on ebay

YYZ

If budget is a concern, buy a set of '68 Mustang fog lights that don't have the crossbar on the chrome bezel.  Should be under $100.

There are some cheaper versions that have a lot of extra rivets around the outside of the housing — avoid those.

Earlier lights will work, but the hole for the wiring is in a different place on the back.

As for bulbs, it is a standard 4415 sealed beam which you can get at any auto parts store. 

Assembly line lamps came with either Westinghouse or GE bulbs (the GE bulbs have FOG embossed on the bottom)

NOS Chrysler replacements were from Wagner and had TS in the middle of the lens (Tung-Sol). AFAIK these were never used at the factory.


anlauto

PG Classics has the "FOG" bulbs for $35/each :alan2cents:
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration

drew43a

Yes i saw the bulbs at PG they are aftermarket repros which is fine.  i just happen to find old stock GE  ones with Fog on them.