1970 challenger Rear finish panel nuts

[tparker]

Can some share a pic of the nuts for the rear finish panel for a 70 Challenger?

Thanks
Tom

[headejm]

The rear finish panel for a 1970 SE is held on by 2 different clip/nut combinations. The attached photos show the two clips on the left side. The right side is two of the three clips that hold the drip rail moldings on. I hope these help. 

Since the photos are flipped, the clip/nut combos you are looking for are at the bottom of the photos. 

[tparker]

 Thank you @headejm. Now I have to source some of these. Do you know where the butterfly looking ones go? The ones on the top seem to be the rectangle ones. I have holes on the bottom, but I thought those were for screws.

Thanks
Tom

[headejm]

Check this thread out. Might be helpful.   

https://forum.e-bodies.org/parts-wanted/25/70-challenger-se-finish-panel-clips/7798/