emblem placement on 2 scoop cuda hood

[1970 cuda Joe]

The hood that on my car is an original Mopar 2 scoop hood but never had hood pins or engine emblems. I figured out the hood pins pretty easy but I need to know where the emblem holes go for the 'cuda 440-6. Everything was painted when I got it so I only have 1 chance to get it right. Any templates out there or some measurements? Thank you, Joe

[MoparCarGuy]

RE: J54 - Sport Hood a.k.a. Cuda Performance Hood (two scoops).

I cannot guarantee this graphic is correct but somebody else can help confirm it.
Depends on if the emblem pin locations are the same for all different emblem versions. I would expect they are.

[MoparCarGuy]

I looked at the non-Shaker Cuda hood emblems and it appears the 2-pin (short pin) design is for the twin-scoop hood and the 3-pin (long pin) design is for the Shaker scoop.
Graphic below for Cuda 440-6 emblems but each of the Cuda 340, Cuda 383, and Cuda 440 emblems have the same spacing for the 2-pin emblems.

[1970 cuda Joe]

I had to wing it a little but I think I'm close...Joe