Auto trans console bracket

[Nepagarage]

I could have sworn I salvaged the entire bracket from the old floor but apparently the only piece I have is the center section directly attached to the shifter. I was going to buy the AMD piece from Classic or another vendor but does anyone else make it? When it comes to doors, fenders, etc I'm all for paying the higher price for the AMD stampings but I feel like that bracket is something I wouldn't mind buying from a "lesser" manufacturer if it can be had.

[JonH]

@Nepagarage
Is this what you are looking for? If you can use it, it is yours if you cover shipping. You can pm me here.

[Claudia]

Proper installation will require all three brackets for the automatic console mounting.  If you already have the center bracket that the shifter mounts to then I wouldn't think the other two brackets would be to hard to fabricate if you have the tools and time. 

[anlauto]

I have all three that were carefully removed from my 71 Cuda if you still need them ?

[Nepagarage]

Sorry for the delay on getting back to you guys. I knew I had the center piece I removed from the old floor. I have a pile of junk around the back of the garage that contains mostly scrap etc. I looked in there yesterday and found a piece of the rotted floor that still has the front most piece attached so I'm good there! I'm going to get out there tomorrow and double check to see if the rear piece was also tossed by accident, I'm guessing I'll come across it. I appreciate you guys offering up the pieces, hopefully I find the third piece and I'll be good to go! Thanks again!