Clutch crossover shaft

[1970 cuda Joe]

Did the crossover shaft for the clutch have 4 nylon or bronze bushing/bearings for the ball stud on the frame & block? Thank you, Joe

[larry4406]

When I converted my '72 to a 4 speed using factory parts, I had (4) nylon female ball bearings.

Two at each end to engage the ball stud on the tranny and two at the frame ball stud.

[1970 cuda Joe]

Thank you. I found the crossover shaft was about to fall of the car giving a feel of no bushings. The big nut on the frame rail could be removed by hand & the one on the block took about an 1/8 of a turn to tighten. I was wondering why the clutch required so many adjustments. Avanti, next project.....Joe

[ec_co]

I just happened to be looking at this diagram yesterday because I'm mocking up my four-speed.

https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/70-aar-diagram-for-z-bar-clutch-to-bell-housing/11174/

Brewers has the rebuild kit

https://www.brewersperformance.com/product/csk-torque-shaft-service-kit-less-ballstuds/