More fender turn signal questions

[1970 cuda Joe]

Happy Halloween everybody

I'm finally getting back to my fender mounted turn signal lights on the 1970 cuda.
There was a barrel clip that came with everything. I'm guessing that snaps into the fender & the light housing pushes through it...correct? Some of the drawings I've seen indicate that it goes below the fender. Thank you, Joe

[1970 cuda Joe]

Dennis from Kruzin Moons answered my question this morning. Thanks to the 78 people that looked at my concerns....Joe

[MoparLeo]

Tell everyone the answer in case someone else has the same question.

It really helps members to share information.
 It might help you someday.

[1970 cuda Joe]

I was correct on my thoughts of the barrel clip. It pushes into the hole in the fender & the pin on the t/s light housing pushes through it, kind of in the same manner as you might install emblems with pins instead of tape....Joe

[cuda hunter]

Thanks for the answer.  78 people didn't know the answer and now they do. Pics help also.
Glad you got the information!

[1970 cuda Joe]

Thanks for the answer.  78 people didn't know the answer and now they do. Pics help also.
Glad you got the information!

I didn't think it would be a hard question to answer. There was quite a few 70 cudas built with the A01 option....Yes? I'm just trying to put back some of the things that were gone. I had enough evidence to say that car had that option. I need to invest in another camera as mine died & I'm a flip phone type of guy.....Joe

[Jay Bee]

I added the A01 to may car and just used PAL nuts instead of the clip to secure those to the fenders. Picture is from another thread on here

[1970 cuda Joe]

Well, I guess i'm still not there yet. The housing & gasket sit on the top of the fender. Was the light assm with lens, bulb & pigtail designed to go from the bottom side, through the hole in the fender & the little screw go through the bracket into the housing? Sorry. Just trying to undo what has happened to the car years ago & I think the big hole in the fender is too small. Maybe somebody could measure the big hole please.....Thank you, Joe

[70_440-6Cuda]

Well, I guess i'm still not there yet. The housing & gasket sit on the top of the fender. Was the light assm with lens, bulb & pigtail designed to go from the bottom side, through the hole in the fender & the little screw go through the bracket into the housing? Sorry. Just trying to undo what has happened to the car years ago & I think the big hole in the fender is too small. Maybe somebody could measure the big hole please.....Thank you, Joe

I have an original 1970 fender with the turn signal mounting - I will try to get over to storage and take a few photos and measurements

[1970 cuda Joe]

Thank you. I measured the hole in the gasket & it measures .600....Joe

[Jay Bee]

Lots of measurements here too.

https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/fender-turn-signals/1620/

[1970 cuda Joe]

Lots of measurements here too.

https://forum.e-bodies.org/cuda-and-challenger-general-discussion-roseville-moparts/2/fender-turn-signals/1620/

In the one picture it looks to be 5/8". Thank you, Joe