Quarter glass Channel / Trim removal and install

[Rbob]

Anybody have suggestions for removing this trim?  I tried a block of wood and hammer, maybe a bigger hammer?

[anlauto]

Undo the stainless at the bottom and pry off from the bottom up....

[Rbob]

I removed the 2 screws at the bottom, I will try prying it off tomorrow. 

Thank you!

[Rich G.]

I use lacquer thinner to soften up the tape and get a razor blade to dig out some of it too.

[Rbob]

I removed this morning, super easy with a little help from a heat gun.  Once heated it pulled off and no hammer or block needed.  The lower section I pulled off without heat as it was a little loose.

Pretty sure I have to use a hammer and block of wood to install.

[Rbob]

I ordered glass sealing tape to reinstall glass into the channels, not knowing how to install I searched and found some cool instructional videos, thought I would share:



removal of channel from glass:
https://youtu.be/puzmpQ3Go5Y

installing the channel / trim with sealing tape:
https://youtu.be/zUY1XXIBiiA