Tell me what you think

[Timbbuc2]

Putting my drip rails on today, first time to see them on the car, to me it don't look right. There is about 3/4" gap from the end of the drip rail to the door chrome. I can see the edge of the vinyl on the A pillar . What have I done wrong
Tim

[Cuda Cody]

Photo?

[Timbbuc2]

Will do tomorrow

[RUNCHARGER]

I think it's probably normal but I don't have a car I can measure it on right now.

[Timbbuc2]

@Cuda Cody , one picture is the driver's side, that I don't likr,the other picture is where I moved the drip rail forward.

[Cuda Cody]

Nothing looks odd to me in that photo. 

[Timbbuc2]

Drivers side

[Brads70]

    I assume these are for non SE trim roofs?

[Timbbuc2]

Nothing looks odd to me in that photo. 

That's the side I moved,

[Chryco Psycho]

there si a small corner piece that fits at the bottom

[Timbbuc2]

Really, that's good info, will have to look for that, thanks @Cuda Cody

[anlauto]

I would say your door is likely lower on one side. You also need the "A" pillar vinyl top trim pieces as shown in Brad's picture.

All except one hole for that front piece of drip rail molding are slotted holes. The purpose of the one hole, found at the bottom of the "A" pillar, is to "locate" the trim in it's correct location.

[Timbbuc2]

Thanks @anlauto , @Brads70  and others, I will look through my stash for those parts when I get this baby done I will be ready for another one lol

[Timbbuc2]

Well don't have that trim piece, the search continues lol

[Timbbuc2]

I found a set of the triim, Tony had them, cost 40 USD, which I thought was a fare ptice.