Yellow Ink Stamp for Dana 60 rear tube

[KZ]

Can anyone help with this?

My 1970 Dodge Challenger RT/SE 440-6 needs the yellow ink stamp on the rear end tube. From what I have gathered I need this number, 081   (9 3/4 Dana Rear Axle 4.10 ratio (Sure Grip) 10" Drum & 7290 Yoke)

I saw several posts by CudaCorey about 8 3/4 rear end stamps but I have not been able to find any info on how to order for the Dana 60

I'm showing my car at this yr's MCACN show and would like to add that touch to the car

Thanks

[anlauto]

We have all the ink stamp artwork here and a link to the place to order them from. BECAUSE E-BODIES.ORG ROCKS !!!
https://www.e-bodies.org/resources/mopar-stamps-stencils-paint-ink-part-numbers/

[KZ]

Alan, I may be stupid, but I don't see any mention of where to order the Dana 60, 9 3/4 stamp, I see 8 3/4 stamp but not for the Dana

[anlauto]

Oh, I'm sorry my bad....just re-read you initial post.
To the best of my knowledge the stamps are the same for both  but I'm no expert. What does the Dave Wise book say ?

[KZ]

I don't have that book so I cannot answer, I was hoping someone out there had the answer. I hate to buy a whole book for one question

[anlauto]

I don't have that book so I cannot answer, I was hoping someone out there had the answer. I hate to buy a whole book for one question

yea you and me both..

[VCODE]

Can anyone help with this?

My 1970 Dodge Challenger RT/SE 440-6 needs the yellow ink stamp on the rear end tube. From what I have gathered I need this number, 081   (9 3/4 Dana Rear Axle 4.10 ratio (Sure Grip) 10" Drum & 7290 Yoke)

I saw several posts by CudaCorey about 8 3/4 rear end stamps but I have not been able to find any info on how to order for the Dana 60

I'm showing my car at this yr's MCACN show and would like to add that touch to the car

Thanks

I have a 081 stamp( for a 70 4:10 Dana) that I had made from rubberstamp. It came out very nice. I will let you use it if you want.
You can call me 914-843-9617
Bob

[76orangewagon]

Didn't Dana 60 axle tube take a sticker like the one offered by ECS Automotive concepts ? Looks like CDX 16 is what you need instead of a stamp.

[VCODE]

Didn't Dana 60 axle tube take a sticker like the one offered by ECS Automotive concepts ? Looks like CDX 16 is what you need instead of a stamp.

Yes they did on the left side of axle. They still have a number on the right side.
Bob