Instrument panel switches

[superwrench]

Where do you guys get new (or rebuilt) headlight and dash dimmer switches ? They look pretty pricey for NOS ones on the internet...

[Chryco Psycho]

Slotts / JS restorations

[Headjam]

 

[RUNCHARGER]

I have a few spares I am tempted to take apart and see what it would take to clean them up. They can't be too complicated.

[superwrench]

I was tempted to take these ones apart. But without  spares, I better not!!

[superwrench]

...OH.... and by the way...thank you guys for the tip on JS  !

[Chryco Psycho]

Glad to , Jim is awesome , helps both you & him out 

[Slotts]

@Chryco Psycho Thank you, Neil. You have always had my back! I really appreciate that!

Here is a link to a photo documentary of some of the services I offer. Sorry, no more plastic restorations... There were too many irons in the fire. Click here.

@superwrench I would be glad to help. Email works the best. Watch out for the Taiwan repop electrical parts. They're junk!

Yes, restoring Mopar electrical parts is so easy, even a caveman can do it!



Jim

[76orangewagon]

I just received my switches and relays back from Jim@ JS Restorations and am more than pleased with not only the parts but the great customer service as well. 

The top two pics are how Jim received them and the last two are after restoration.

[ZEN357]

Junk yards or swap meets.

[Slotts]

I just received my switches and relays back from Jim@ JS Restorations and am more than pleased with not only the parts but the great customer service as well. 

Ross. I am glad you are pleased with everything and appreciate your support!

Jim

[VCODE]

Jim is the Man. Your beard got a little long

[Morty426]

I just received my switches and relays back from Jim@ JS Restorations and am more than pleased with not only the parts but the great customer service as well. 

Ross. I am glad you are pleased with everything and appreciate your support!

Jim

@Slotts  how can you test the dimmer to determine if it is good or bad?

[Chryco Psycho]

You can put an qhm meter across it & see if the resistance changes as you adjust the dial  , if it goes open at any point contact is lost or the resister is broken

[Morty426]

You can put an qhm meter across it & see if the resistance changes as you adjust the dial  , if it goes open at any point contact is lost or the resister is broken

I figured that but I am looking for place the ohm meter at this place and this place and turn the knob and it should do yada yada