Is this the correct column torque shaft?

[Rutro]

OK....I'm trying to put on my column lock torque shaft Z bar and I don't think I have the correct version.
I have automatic with floor console. Looking at the manual it appears the U shape on the shaft needs to be closer to the transmission.
What one do I have? Does anyone have the correct one? Thanks, Mark

[Cuda Cody]

The U shape notch is to clear the exhaust, right?

[anlauto]

That one in the above picture is for an Automatic, it goes under the exhaust. The four speed one goes over the exhaust.

[anlauto]

Your picture looks different them mine. Mine is correct for a 440/727 set up. Keep in mind a 318/904 set up would be different I believe. There are probably a few different ones.

[Rutro]

I have a 440 w/ the 727
Yes yours  looks like the U shape to clear the exhaust is closer to the transmission.
That's what I was afraid of.
Anyone have the correct one?

[fc7cuda]

Where in Texas are you pardner, I might have some to check out.

Tom