Main Menu

71 cuda std dash to ralley

Started by Qda71, April 28, 2024, 05:37:54 AM

Previous topic Next topic

0 Members and 1 Guest are viewing this topic.

Qda71

What parts are involved beside the ralley instrument cluster,light bar ,underdash harness. Dash heater piece and switch panel!
Just Love all american iron ... but i have a soft spot for ebody mopars.

Katfish

Engine wiring to coil for tach
Change engine oil sender to a pressure unit

ZippyZoo

This might be a good time to consider ammeter/alternator bypass if you haven't done that already. Related-might consider changing ammeter to volt meter. There are several threads discussing each on this site!  :alan2cents:


Jay Bee

Need to run a wire with an eyelet terminal to the oil gauge. I spliced into the grey wire on the oil light (standard dash) when I did my conversion.

larry4406

I recall there used to be a "conversion harness" that was available aftermarket for this to avoid cutting.

Skdmark

Rallye dash cars also came standard with the 3spd wiper setup and electric squirters.
You are not entitled to your opinion. You are entitled to your informed opinion. No one is entitled to be ignorant.
-Harlan Ellison

(O OI====II====IO O)    (O O{]{]{] ][ [}[}[}O O)
:stayinlane:

anlauto

Why change an otherwise beautiful restored car ?
I've taught you everything you know....but I haven't taught you everything I know....
Check out my web site ....  Alan Gallant Automotive Restoration