Need help locating U joint

[blown motor]

This is on an 83 Dodge W150 truck. I'm looking for the U joints that go in the transfer case end of the forward driveshaft. It's a CV joint so there is two of them. We've looked everywhere and tried several but cannot come up with the right ones. Does anybody know of a driveline company that might be able to set me up with the correct ones? We have the little ball(?) joint that goes in the middle between them.

[anlauto]

Maybe Trans-Axle in Stoney Creek  I get my drive shafts made there https://stoneycreek.transaxleparts.ca/

[dodj]

It's a CV joint so there is two of them.

Double cardon not CV...but parts stores will usually sell the whole assy instead of the joints...about $600 though.

[BIGSHCLUNK]

Murray, maybe one of my old Hollander book will say? Whats the exact year ect ect... 

[blown motor]

@dodj Thanks for the clarification on that. You can see in the first picture that the groove for the retaining clip is more outward on the cap and not on the inside like almost every joint on the planet.

[blown motor]

@BIGSHCLUNK It's an 83 W150 so I'm told. (Frankenstein truck,   
lol)

[BIGSHCLUNK]

ok, now the fun part....

1 piece shaft... (rear) 
131 wheel base ? 
stick or auto??
440 ???
removable carrier or rear cover?

isn't this fun... 

[BIGSHCLUNK]

I'm guessing... a #7290   but more info is better

[blown motor]

This is the shaft from the transfer case to the front axle. Don't know what engine was originally married to that chassis. Single cab with 8' box, not sure what that makes the wheel base without measuring it.

[BIGSHCLUNK]

Ok we should be good on the 131WB then. 
is it 16 spline... ?  try #7260

[blown motor]

@BIGSHCLUNK  I'll have to do a count. Right now I'm drinking beer. Priorities.

[jimynick]

A man's got to know his priorities for damn sure and it sounds like you're there laddie. Have one? for me! 

[BIGSHCLUNK]

      

[blown motor]

@BIGSHCLUNK  Yes, 16 spline.

[BIGSHCLUNK]

I'd try the #7260