Replace service kit with an adjuster clutch ball at fork

[Topcat]

Rick Ehrenberg once offered a clutch adjusting "problem solver" on his e bay.

The adjuster rod service kit which is normally found was upgraded to a ball that fit right in the end of the clutch fork.

I found it to be a really good upgrade yet I don't see it available anymore.

@Chryco Psycho once mentioned it was on Ram truck I believe?

Thoughts on it CP?   

Worth getting if you are having to re adjust clutch play more often than you'd like.

[Topcat]

I just e-mailed Rick so I will reply back if he answers.

[Chryco Psycho]

I used to get them out of mid 80s Ram trucks & vans , not available from Mopar any more

[Topcat]

Rick just replied:

Down to the very end on these:

https://www.ebay.com/itm/223208300949

[Chryco Psycho]

I likely have 10 or more of them with all of the 4 spd conversions I was doing But they are roughly 4000 miles from me

[Topcat]

I would think pretty easy to make.

[Topcat]

Available again.


Rick e-mailed me:  https://www.ebay.com/itm/323668778487

[GrandpaKevin]

Both my 4 speed cars have them and they are much better than the stock setup.
I've used them for many years but I'm not even sure where I bought them.

[Chryco Psycho]

They were stock but in trucks not cars , I would scavenge them from wrecking yards

[Topcat]

His most recent e-mail:

I bought these from the Chrysler dealer 20 years ago, I bought all that were available when the parts manager told me they were discontinued, I'm down to about three or four, so that's the end of the line.

[Chryco Psycho]

I bet Brad could make some easily

[YellowThumper]

If there is any interest for more of these, they look like something easily produced.
Send some measurements, or... If one was at the Woodley Park show I could make measurements from it. or...X2 purchase one myself.


Mike.

[Topcat]

Rick says he has a few left.

https://www.ebay.com/itm/323668778487

[70 Challenger Lover]

If there is any interest for more of these, they look like something easily produced.
Send some measurements, or... If one was at the Woodley Park show I could make measurements from it. or...X2 purchase one myself.


Mike.

I have one of these I'm planning to use soon. I could take some detailed measurements and pictures if you're offering to reproduce some. I'd like a couple more, one for a second car of mine and maybe a couple to keep for future use. There aren't any currently on eBay but at $30-35, it's worth it.

[YellowThumper]

If there is any interest for more of these, they look like something easily produced.
Send some measurements, or... If one was at the Woodley Park show I could make measurements from it. or...X2 purchase one myself.


Mike.

I have one of these I'm planning to use soon. I could take some detailed measurements and pictures if you're offering to reproduce some. I'd like a couple more, one for a second car of mine and maybe a couple to keep for future use. There aren't any currently on eBay but at $30-35, it's worth it.

Yes, that was the suggestion. Would make a few. Not necessarily for $$$. In the trade of machining . Just what I do...
Dimensions would be great.
Thanks.