Recent posts

#1

Electrical & Audio / Re: Intermittent problem with ...

Last post by Skdmark - Today at 09:12:51 PM

Is the vacuum advance on the distributor hooked up?

#2

Interior / Shipping seats

Last post by 71GranCoupe - Today at 07:33:36 PM

I have a set of 70-71 E Body seats and wondering if anyone has tried shipping them. Do they have to be split for shipping or??? Any insight is appreciated. thanks for any suggestions, as I don't want to list them if shipping is difficult or just not practical.

#3

H

Interior / 70 Cuda Front bucket seats sea...

Last post by HemiRod - Today at 05:28:59 PM

My 70 Cuda has date code 1969-3 on the original belts in car.  Missing the 2 lap and shoulder buckles. I have seen a couple and their labels say Chrysler Corp 2999585 and code F 3569.  I checked in 70-71 Chrysler parts catalogue and this label number is not there.  The 4752 is the part number. what does F 3569 mean.  I thought it may be 356 day of 69.  However, I saw another with F 5069...only 365 days in a year, so I must be wrong.

Please help if you can.

#4

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers

Last post by headejm - Today at 04:32:16 PM

I bought this relatively inexpensive Dorman kit. Has not leaked in four or so years.

#5

X

Electrical & Audio / Re: Alternator Bypass Wire Rou...

Last post by Xghobo - Today at 04:18:26 PM

It looks like crackedback has not been on the forum since Nov 2023.
Hope he's ok.

I spoke to him about 2 months ago and am pretty sure he is retired. I had to go elsewhere

#6

1

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers

Last post by 1970 cuda Joe - Today at 04:03:33 PM

I'm thinking the aftermarket is too hard & not allowing it to crush....Thank you, Joe

#7

1

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Is this a partial VIN?

Last post by 1970 cuda Joe - Today at 04:00:45 PM

a 1968 non-HP engine will not have a VIN stamping

Thank you. I'm beginning to see that....Joe

#8

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Is this a partial VIN?

Last post by 6bblgt - Today at 03:12:13 PM

a 1968 non-HP engine will not have a VIN stamping

#9

Parts Wanted / Rallye Dash Light Bar Lens

Last post by fc7cuda - Today at 02:57:21 PM

I'm looking for an original rallye dash light bar lens.  If anyone upgraded their lenses and happened to save the originals, please PM me.  A little warped is ok, I'll make it work. 

#10

Cuda & Challenger General Discussion (ROSEVILLE MOPARTS) / Re: Caliper sealing washers

Last post by Katfish - Today at 01:01:51 PM

I had similar problem.  Not all copper washers are equal.
Most of the aftermarket washers are thinner than factory.
I ended up buying some washers from local dealer, and that worked.
Mopar Action had an article on the issue.