Getting these bushings out suck, any pros here? The circled one:
Drill out the two spot welds that hold the strap to the frame bracket.
Does anyone reproduce those bushings anymore?
If you don't need it factory correct, poly will be cheaper and better performing alternative. Don't think they have the back reproduced.
What Burder said is the best way....Drill out the Spot Welds, from the back side of the strap so it's easier to grind the welds down later and still look original from the outside. I soaked my bushings in BP Blaster for a day and they were very soft and pliable like new. Don't soak them to long or they will swell up too big and not be tight on the bar once reassembled.
Thank you!
Heres some pictures I took during the process I described above....also repaired the rot and now it looks new and still shows has that Pentastar and part number.
:popcorn:
Nicely done MrBill!
I may have to attempt to do mine because there does not seem to be a OE type repo of these rear bar setups. Mine appears to be twisted though as the ends where the links attach are not on the same plain. :huh: UNLESS.. one (OE) link is longer than the other? :dunno: My old links are long gone to the trash.
Quote from: Rbob on October 30, 2020, 10:43:57 AM
Getting these bushings out suck, any pros here? The circled one:
By no means am I a pro but I have separated the bushing from the bracket. It's been a while ago that I originally did these, here's what I remember.
All the rust between the rubber and steel had to be broken/softened/removed whatever. I don't really know how to explain that. I used various flat blade screwdrivers to work WD40 (and any lubricant I had on hand) in between the bushing and bracket from both sides. Eventually the rubber broke free from the steel and a combination of pushing and pulling got it out of the bracket. By "pulling" I mean I used the flat blade screwdrivers like a lever. You can see the minor damage this caused on the top of the bushing. For fun I went downstairs and just removed one for the pictures.
There's some great info in the following thread if you haven't seen it.
https://forum.e-bodies.org/engine-transmission-and-rear-end/4/rear-sway-bar-bushings/10579/
After Blasting I drilled out one weld, that will allow re-install of oem bushing. Thanks for the tip!